Vident
iSmart900 allow you to do oil reset operation
for vehicle.Here UOBD2 show you how to use Vident iSmart900 to reset
oil light.
Procedures:
Built connection between vehicle and
Vident iSmart900,and
enter the service and maintenance operations to select “Oil Service”,it can be
found under the main diagnostic menu.But in most of the case, are under the specific control module.
Oil service reset methods are determined by
the vehicle being tested.
Typically
there are three methods:
1.Oil Reset With One Button
2.Manual Reset
3.Auto Reset
Oil
Reset With One Button
To do Oil Reset With One Button on a 2016
VW passenger car:
Slide the screen to tap Oil Life Reset from
the diagnostic menu. Select the type of reset applicable to your car and tap
the function key OK to continue or Cancel key to return to the Oil Reset menu.
Follow on-screen instruction and send a
command to reset oil service. A screen with “Success” message displays once the
lamp has been reset. Tap any key to return.
Manual
Reset Oil Light
Almost all Asian vehicles and most American
and European vehicles have mechanical oil service indicator reset. The service
tool does not have to communicate with the vehicle being tested, but guides you
to complete the service manually by providing step-by-step on-screen instructions.
When Manual Reset is selected and the vehicle being tested identified, a procedure
opens on the screen. Slide the screen to read the entire procedure and
performing the necessary steps as directed by the on-screen instructions.The
exact order of the test operation steps may vary depending on the test vehicle.
Be sure to follow all on-screen instructions.This manual reset procedure can be
interrupted and aborted if the ignition key position is changed.
To
do oil reset manually:
1.Select Engine Control Module and follow the
on-screen menu to select Oil Interval Reset.
2.The following procedure screen displays.
3.Follow all on-screen instructions to
perform the manual mechanical reset.
4.Tap OK key to return.
Auto
Reset Oil Light
Auto Reset is a bi-directional communication
procedure directed by the service tool. The service tool displays guides for
you through the process. A number of instructions that require a response to
continue display, including an option to clear any stored codes once the
interval has been reset. Follow the on-screen instructions.
No comments:
Post a Comment