Vident iSmart900 to Reset Oil Light Guide

Vident iSmart900 allow you to do oil reset operation for vehicle.Here UOBD2 show you how to use Vident iSmart900 to reset oil light.

Procedures:

Built connection between vehicle and Vident iSmart900,and enter the service and maintenance operations to select “Oil Service”,it can be found under the main diagnostic menu.But in most of the case, are under the specific control module.

Vident iSmart900 Manually Locate a Required Control System

This article show you to how use Vident iSmart900 to  locate a required control system manually for testing through a series of choices.Simply follow the menu driven procedure, and make proper selection each time; the program will guide you to the diagnostic function menu after a few choices you’ve made.

To select a system for testing:
1. Select Control Unit from the menu and a controller menu displays.

How to Use Vident iLink400 to Read I/M Readiness Status Data?

Vident iLink400 I/M Readiness option allows to view a snapshot of the operations for the emission system on OBDII/EOBD vehicles.

I/M Readiness is a useful function used to check if all monitors are OK or N/A. The vehicle’s computer performs tests on the emission system during normal driving conditions. After a specific amount of drive time (each monitor has specific driving conditions and time required), the computer’s monitors decide if the vehicles emission system is working correctly.


When the monitor’s status is:
  OK - vehicle was driven enough to complete the monitor.
  INC (Incomplete) - vehicle was not driven enough to complete the monitor.
  N/A (Not Applicable) - vehicle does not support that monitor.

There are two types of I/M Readiness tests:
Since DTCs Cleared - shows status of the monitors since the DTCs were last cleared.This Drive Cycle - shows status of monitors since the start of the current drive cycle.

How to Buy Extra Software for Vident iLink400?

VIDENT iLink400 is authorized with one free software when delivery and can cover up to six vehicle makes.More software can be added anytime at extra cost. You can contact the reseller or following the steps below to buy extra software.

VIDENT iLink400 Extra Software:
1. Log in at our website www.videnttech.com and go to your Member Center, click Registered Products.